Contents
This sample uses the TIBCO StreamBase® SBD-to-SBD Input Adapter in a downstream application to read tuples from an upstream application.
-
In the Project Explorer, double-click to open the
downstream.sbapp
application. Make sure the application is the currently active tab in the EventFlow Editor. -
Click the Run button. This opens the SB Test/Debug perspective and starts the application.
-
For the example, in the Manual Input view select the
InputStream
Stream, then enter123 and abc
into the fields and click send to send the tuple. -
In the Output Streams view, observe that the tuples enqueued to the upstream application are emitted by the downstream application.
-
When done, press F9 or click the Stop Running Application button.
In StreamBase Studio, import this sample with the following steps:
-
From the top menu, click
→ . -
Select this sample from the Embedded Adapters list.
-
Click OK.
StreamBase Studio creates a single project containing the sample files.
When you load the sample into StreamBase Studio, Studio copies the sample project's files to your Studio workspace, which is normally part of your home directory, with full access rights.
Important
Load this sample in StreamBase Studio, and thereafter use the Studio workspace copy of the sample to run and test it, even when running from the command prompt.
Using the workspace copy of the sample avoids permission problems. The default workspace location for this sample is:
studio-workspace
/sample_adapter_embedded_sbd2sbdinput
See Default Installation Directories for the location of studio-workspace
on your system.
In the default TIBCO StreamBase installation, this sample's files are initially installed in:
streambase-install-dir
/sample/adapter/embedded/sbd2sbdinput
See Default Installation Directories for the default location of studio-workspace
on your system.