Contents
This sample demonstrates how to use the TIBCO StreamBase® Input Adapter for IP/POP3.
Note
The adapter uses the WinPcap
(Windows) and libpcap
(Linux) libraries to tap into the IP packet stream. Before
using this adapter with real-time data, you must install and configure these
libraries on the system that will host the POP3 Reader adapter. Download and install
the latest WinPcap from http://www.winpcap.org. For Linux, obtain the tcpdump
package from your Linux distribution, or download, compile,
and install the package from http://www.tcpdump.org.
On Windows, this adapter is supported for use with both 64-bit and 32-bit versions of
StreamBase Server. Download and install the latest WinPcap
version, which supports both 64-bit and 32-bit Windows. For
Linux, this adapter is supported only on StreamBase built for 32-bit Linux
platforms. This sample can only be run on Windows and on 32-bit Linux.
-
In the Package Explorer, double-click to open the
POP3Reader.sbapp
application. Make sure the application is the currently active tab in the EventFlow Editor. -
Click the
Run button. This opens the SB Test/Debug perspective and starts the application.
-
Use a mail client to retrieve a message from a POP3 server.
-
In the Application Output view, observe that a tuple is emitted through the
POP3ReaderOutput
stream. -
When done, press F9 or click the
Stop Running Application button.
This section describes how to run the sample in UNIX terminal windows or Windows command prompt windows. On Windows, be sure to use the StreamBase Command Prompt from the Start menu as described in the Test/Debug Guide, not the default command prompt.
-
Open two terminal windows on UNIX, or two StreamBase Command Prompts on Windows. In each window, navigate to the directory where the sample is installed, or to your workspace copy of the sample, as described above.
-
In window 1, type:
sbd POP3Reader.sbapp
. -
In window 2, start a dequeuer by typing:
sbc dequeue POP3ReaderOutput
. -
Use a mail client to retrieve a message from a POP3 server.
-
A tuple representing the e-mail message appears in window 2.
-
In window 2, type: Ctrl+C to exit the sbc session.
-
In window 2, type the following command to terminate the server and dequeuer:
sbadmin shutdown
In StreamBase Studio, import this sample with the following steps:
-
From the top menu, click
→ . -
Select this sample from the Embedded Adapters list.
-
Click OK.
StreamBase Studio creates a single project containing the sample files.
When you load the sample into StreamBase Studio, Studio copies the sample project's files to your Studio workspace, which is normally part of your home directory, with full access rights.
Important
Load this sample in StreamBase Studio, and thereafter use the Studio workspace copy of the sample to run and test it, even when running from the command prompt.
Using the workspace copy of the sample avoids the permission problems that can occur when trying to work with the initially installed location of the sample. The default workspace location for this sample is:
studio-workspace
/sample_adapter_embedded_pop3reader
See Default Installation
Directories for the location of studio-workspace
on your system.
In the default TIBCO StreamBase installation, this sample's files are initially installed in:
streambase-install-dir
/sample/adapter/embedded/pop3reader
See Default Installation
Directories for the location of streambase-install-dir
on your system. This location
may require administrator privileges for write access, depending on your platform.