Configuring the Service
You can customize certain behaviors for the Spotfire Service for R by exporting the service properties, editing the file, importing service properties, and then applying the new configuration.
About this task
Note: For general
information about configuring services for Spotfire Server, see the
Spotfire® Server Installation and
Administration.
Before you begin
- You must have completed the steps outlined in Installing the Service on a Node Manager for a Spotfire Server.
- You must have administrative read-write privileges to save the changed configuration file.
Procedure
Results
Note: To change the new
configuration, export it again, specifying its name. If you do not specify the
name, the default configuration is exported.
- Custom configuration properties
You can fine tune the behavior of the Spotfire Service for R by setting custom configuration properties.
- Custom configuration properties
You can fine tune the behavior of the Spotfire Service for R by setting custom configuration properties.