Configuring the TIBCO Service Performance Manager Server

You can use TIBCO Configuration Tool to configure the Service Performance Manager server. TIBCO Configuration Tool is launched using TIBCO_HOME/tct/<version>/TIBCOConfigurationTool.

When TIBCO Configuration Tool starts, the initial data is loaded from TIBCO_HOME/tct/components/shared/1.0.0/plugins/com.tibco.tct.spm_1.0.0.00X. Alternatively, you can manually change the properties specified in the SPM_HOME/config/spm-config.properties file.

Procedure

  1. Open the spm-config.properties file in the SPM_HOME/config folder for editing.
  2. Uncomment the required property, and specify a new value.

Result

Note: TIBCO Configuration Tool does not recognize the changes made directly to the spm-config.properties file. Hence it is recommended to always use TIBCO Configuration Tool to make changes to the configuration.
Note: To start TIBCO Configuration Tool in the console mode, perform the following steps:
  • On the command prompt, navigate to TCT_HOME/<version>.
  • Start TIBCOConfigurationToolc -consoleMode to launch TIBCO Configuration Tool.

Before going through the procedure, ensure that you go through the guidelines in Guidelines for Running TIBCO Configuration Tool in the GUI Mode.

Contents
Search Results