Configuring connectors for use with web clients and Spotfire Automation Services
If connectors should be available for users of Spotfire web clients, or in Spotfire Automation Services, some configuration on the Spotfire Server is necessary.
About this task
Procedure
- Authentication modes for connectors
You may have to change the authentication mode for some connectors so that they are available for use with Spotfire web clients. This is done in theSpotfire.Dxp.Worker.Host.exe.config
file. - Connector configuration examples
By default, all Spotfire connectors are listed in the configuration file,Spotfire.Dxp.Worker.Host.exe.config
, and all connectors usePrompt
as authentication mode. - Connector names in configuration file
This list describes how to refer to the different connectors in the configuration file Spotfire.Dxp.Worker.Host.exe.config.
- Authentication modes for connectors
You may have to change the authentication mode for some connectors so that they are available for use with Spotfire web clients. This is done in theSpotfire.Dxp.Worker.Host.exe.config
file. - Connector configuration examples
By default, all Spotfire connectors are listed in the configuration file,Spotfire.Dxp.Worker.Host.exe.config
, and all connectors usePrompt
as authentication mode. - Connector names in configuration file
This list describes how to refer to the different connectors in the configuration file Spotfire.Dxp.Worker.Host.exe.config.
Parent topic: Connectors