Install the new node manager on the same computer as the old node manager. You must run the node manager installer with administrative permissions.
Before you begin
- Spotfire Server is installed and running.
Procedure
-
In the installation kit, right-click
nm-setup.exe and then click
Run as administrator.
-
On the installation wizard
Welcome page, click
Next.
-
On the
License page, read the agreement, select
I accept, and then click
Next.
-
On the
Destination Folder page you can change the location if you want to, and then click
Next.
The
Node Manager Ports page opens.
-
On the
Node Manager Ports page, specify the same ports that were used by the old node manager.
-
Click Next.
The
Spotfire Server page opens.
-
On the
Spotfire Server page, enter the following information, and then click
Next.
Important: These values must match the values you used when installing the
Spotfire Server files.
- Server name–The hostname of
Spotfire Server.
Note: Valid hostnames may contain only alphabetic characters, numeric characters, hyphens, and periods.
- Server backend registration port–The registration port that you specified during
Spotfire Server installation.
- Server backend communication port (TLS)–The back-end communication port that you specified during
Spotfire Server installation.
-
On the
Network Names page, select the computer names that can be used by back-end trust. In general you can leave all the listed names as they are.
-
On the
Ready to Install page, click
Install.
Important: Do not start the newly installed node manager before running the upgrade tool.
-
On the
Install Wizard Completed page, select
Launch the upgrade tool and click
Finish.