Upgrading a cluster of Spotfire Servers
Spotfire Server clustering is enabled by default.
About this task
For information on upgrading, see
Upgrading Spotfire. For
general information on clustering, see
Clustered server
deployments.
Note: If you have a load
balancer that routes based on the jvmRoute part of the session id, note that
the default value has changed from uppercase to lowercase. If needed, update
the load balancer configuration accordingly.
These are the basic steps for upgrading a clustered implementation of Spotfire:
Procedure
- Download the required software; see Downloading installation software.
- Install the Spotfire Servers in your cluster; see Installation of Spotfire Server during upgrade.
- Run the upgrade tool on each server in the cluster; see Run the upgrade tool.
- On one of the servers in the cluster, set your clustering parameters; see Setting up a cluster of Spotfire Servers.
- Start the same server; see Start or stop Spotfire Server.
- Start the other servers in the cluster.
Parent topic: Upgrading Spotfire
Related concepts