Changing server and node logging levels

When Spotfire Server alerts you to an issue in your implementation, you can switch to a more complete logging level from within the Monitoring & Diagnostics area of the Spotfire Server web administration interface .

Before you begin

You must have administrative credentials for Spotfire Server.

About this task

Note: Alternatively, you can change logging levels by using the set-logging command. For information on using the command line, see Executing commands on the command line.

Note: It is a good practice to back up the existing logs and clear the logs folder before capturing the debug logs.

Procedure

Log in to the Spotfire Server web administration pages and click Monitoring & Diagnostics.
On the Overview page, select the servers or the nodes whose logging level you want to change.
Click Set log configuration, select a different logging level, and click Set.

Results

The changes are shown in the Log configuration column.

Note: When the troubleshooting is completed, you should switch back to a lower logging level. You can return quickly to the Standard (default) level by selecting the server or node and clicking Reset log configuration.