Defining a FastPath Trigger

The following steps shows you how to configure a FastPath trigger.

1. From the main ISPF panel, select option 7, Define Triggers - Outbound Convert / Destinations.
2. On the command line, enter ADD to create a new trigger.
3. Select the ESB Endpoint to be used by the trigger and press Enter.
4. Optionally, select a conversion rule and press PF3.
5. Specify Trigger Identifier.
6. Specify a destination name for the Publish To field.
7. Specify Trace Level for your desired level of debugging.
8. Specify Output Method of either 2 or 3.
9. Modify Compare Text as needed.
10. Modify Undelivered Requeue as needed.
11. Configure the endpoint, as described in the appropriate section:
    • Endpoint Configuration for Rendezvous ESB
    • Endpoint Configuration for EMS ESB

• Endpoint Configuration for Rendezvous ESB
  If the endpoint is a Rendezvous ESB:
• Endpoint Configuration for EMS ESB
  When you use the FastPath process with a trigger service, consider the following requirements based if the endpoint is EMS ESB.

Copyright © Cloud Software Group, Inc. All rights reserved.