Simple no configuration installation
A simple standalone Spotfire Statistics Services installation requires no additional configuration.
If you install a standalone Spotfire Statistics Services on a computer that meets the minimum requirements, you require no post-installation configuration. (See System Requirements.)
You can customize the configuration after installing Spotfire Statistics Services and check that it is operating normally. To verify that your installation is running normally, see Validation.
Review the service property information to determine which settings to customize. For example, by default, the configuration file requires no authentication. If you want to enable authentication, change the default value to
true.
Note: By default, if your engine type is
TERR, then
TERR is set to use restricted execution mode. To change the properties that control this option, you must edit the
spserver.properties configuration file. See
Server properties for more information.
Related concepts
Copyright © 2021. TIBCO Software Inc. All Rights Reserved.