Feed Simulation Input Adapter Sample

About This Sample

This sample demonstrates the TIBCO StreamBase® Feed Simulation Input Adapter emitting data on two different streams. The two streams have identical schemas and both use data files as data sources. The data files contain fictitious market data captured from two different venues at the same time and for the same instruments. The two streams emit data based on an arrival timestamp and the two streams are time synchronized. In this way, the feed simulation emits data very close to the way two real market data handlers would emit actual market data.

The same feed simulation configuration file in this sample (src/main/resources/sbfeedsim.sbfs) can be used by the sbfeedsim or epadmin start playback command line tools. Each of these approaches might be preferred under different circumstances.

Importing This Sample into StreamBase Studio

In StreamBase Studio, import this sample with the following steps:

  • From the top-level menu, select File>Import Samples and Community Content.

  • Enter sbf to narrow the list of options.

  • Select Feed Simulation embedded input adapter from the StreamBase Standard Adapters category.

  • Click Import Now.

StreamBase Studio creates a project for the sample.

Running This Sample in StreamBase Studio

  1. In the Project Explorer view, open the sample you just loaded.

    If you see red marks on a project folder, wait a moment for the project to load its features.

    If the red marks do not resolve themselves after a minute, select the project, right-click, and select Maven>Update Project from the context menu.

  2. Open the src/main/eventflow/packageName folder.

  3. Open the sbfeedsim.sbapp file and click the Run button. This opens the SB Test/Debug perspective and starts the module, which is self-running.

  4. The Feed Simulation adapter begins to emit data immediately. You can suspend, resume, and scale the tuple rate by sending commands to the input stream using the Manual Input tab in the SB Test/Debug perspective.

  5. When done, press F9 or click the Terminate EventFlow Fragment button.

Sample Location

When you load the sample into StreamBase Studio, Studio copies the sample project's files to your Studio workspace, which is normally part of your home directory, with full access rights.

Important

Load this sample in StreamBase Studio, and thereafter use the Studio workspace copy of the sample to run and test it, even when running from the command prompt.

Using the workspace copy of the sample avoids permission problems. The default workspace location for this sample is:

studio-workspace/sample_adapter_embedded_sbfeedsim

See Default Installation Directories for the default location of studio-workspace on your system.