Secure ULDP Settings

Set the secure Universal Lossless Data Protocol (ULDP) settings in this section.

The default value of the Secure ULDP field is Off. If you select On, you can change the Secure ULDP Port number and the minimum protocol version. To add the secure ULDP port to the firewall rule when the firewall is enabled, you can run the system firewall command. The default value of Minimum Secure ULDP Protocol is TLSv1.2, and the other options are TLSv1.1 and TLSv1.
  • If you select TLSv1.2, then only TLSv1.2 protocol is supported.
  • If you select TLSv1.1, then both TLSv1.2 and TLSV1.1 protocols are supported.
  • If you select TLSv1, then TLSv1.2, TLSv1.1, and TLSv1 protocols are supported.
  • SSLv2 and SSLv3 are not supported any more.
Note: To import an SSL certificate, you must run the system secureuldp command.