Advanced Feature Settings

Field	Description
Advanced Features	Enables or disables the Advanced Features. The default is Off (disabled). Select On to enable the following Advanced Features: Advanced Search Advanced Dashboards Bloks: Filter, Correlation, and Time Bloks Data Models Enrichment Lists Exporting and Importing Configurations Only an administrator with CLI access using root can use this feature. For more information on exporting and importing configurations, see the "Import or Export Entities Between Appliances" section in TIBCO LogLogic® Log Management Intelligence Administration. Monitoring Console Monthly index Queries Search queries Scheduled queries Tail queries Distributed Advanced Search queries REST API support for Advanced Search Rule Management: Triggers Aggregation rules Distributed aggregation rules Important Considerations After enabling the advanced features, all sessions to the WebUI are disconnected for the period when the Tomcat engine restarts, after which users can login again. Advanced Features are not supported on: A standby node in a high availability setup. However, Advanced Features are accessible using the public IP address or the IP address of the master node. Before configuring HA, you must disable Advanced Features on both master and standby appliances. Use caution when enabling Advanced Features on TIBCO LogLogic® LX1025R1 Appliance, because the memory requirements of these features when in use might cause performance issues. Also, continuous use of Advanced Features on this model can cause the appliance to run out of memory and lead to engine restarts or failure. For information about the behavior of Advanced Aggregation and Monitoring Console features after upgrading to LogLogic LMI 6.3.1, see the Upgrade Considerations section in TIBCO LogLogic® Log Management Intelligence Configuration and Upgrade. For information about enabling advanced features using the CLI, see the `system logu` command.
Monitoring Console	Enables or disables the Monitoring Console and displays the Monitoring > Console menu. You can enable or disable this feature using the CLI by running the `system monitoring_console` command.
Advanced Aggregation	Enable or disable the Advanced Aggregation features. After enabling the Advanced Aggregation option, the Management > Rules > Aggregation tab is visible to users and they can use the Advanced Aggregation features. By default, Advanced Aggregation is switched off. This feature can be enabled only if the Advanced Features option is enabled. If Advanced Aggregation is switched on before upgrading your setup, it remains switched on after the upgrade. Important: Before disabling Advanced Aggregation, ensure that you delete or disable any advanced aggregation rules to avoid storing unnecessary aggregated data. To enable or disable this feature using the CLI, see the `system advanced_aggregation` command.
Monthly Index	Enables or disables the monthly index feature. The default is No. This feature can be enabled only if the Advanced Features option is enabled. For information about enabling monthly index using the Command Line Interface (CLI), see the `system monthly_index` command.
Monthly Index Load Divisor	When the monthly index is so large that the memory issues occur when loading the terms during an Advanced Search and when Advanced Search and Monthly Index are both enabled, this parameter controls what fraction of the Monthly Index terms are loaded into memory during an Advanced Search. The default value is 1 (load all terms) with a possible range of 1-5, where 5 indicates 1/5th, which means load only 20% of the terms in memory. Note: Reducing the fraction of terms loaded into memory helps with memory issues. However, it has a performance impact on searches where no memory issues exist, because the frequency of disk access during an Advanced Search increases. For information about configuring the monthly index using the CLI, see the `system monthly_index_load_divisor` command.