Edit Configuration File Screen

Use the Edit the Configuration File page with extreme caution. Do not use the page unless the configuration.xml is backed up and specific knowledge about the TIBCO Silver Fabric system is being applied. This interface can be used for more advanced customizations and normally it should be left alone.

For more information, refer "The configure.xml File" section in TIBCO Silver® Fabric Developer’s Guide.
Warning: WARNING! Changes to the configuration.xml can break the installation. Before making any changes to the configuration.xml back it up and secure it. Consult an expert to ensure that any distribution changes are properly made.  More information on the use of the configuration.xml can be found in the TIBCO Silver Fabric documentation.
Edit the Configuration File Page

The remaining screens of the component wizard are generic for TIBCO Silver® Fabric Enablers. These final configurations are optional for TIBCO BusinessEvents components.

Refer to TIBCO Silver® Fabric User’s Guide for more information on the configuration screens.

Click Finish to save your changes and then you can publish the component as part of a stack. To do this, select Publish Component in the Actions drop down list located at the line of the component you just created.