Client Connection Configuration Reference

Adapter for SAP Connection Panel

The Adapter for SAP Connection panel shows the connection name. You can enter a description in this panel.

Run-Time Inbound Panel

The Run-Time Inbound panel shows the client connection settings.

For more information about the fields in this panel, see Client Connection Settings.

In the this panel, you can also specify the following configuration options:

Select the displayed language from the Language list.
The default language is English.
Specify the character sets used by the SAP system and database in the Code Page field.
The field is blank by default.

Client Panel

In the Client panel, you can specify the client that is created with the client connection.

The following is the Client panel:

Fields	Description
Name	Specify the client name. The default name is ClientConnection_NameClient0.
RFC Trace	Set the value to 1 to enable RFC trace. Set the value to 0 to disable RFC trace. The default value is 0. Note: Even though you disable the RFC trace in the adapter configuration, a trace file can be generated due to the setting defined in the RFC destination in the SAP system or parameters defined on the SAP Gateway.
USE SAP GUI	Set the value to 0 to disable SAP GUI to carry out debugging of RFCs. Set the value to 1 to enable SAP GUI to carry out debugging of RFCs. Set the value to 2 to enable SAP GUI to carry out debugging of RFCs until used by an invocation of an RFC. The default value is 0. It is good practice to install the SAP GUI on the same machine as the adapter. If you enter other values, an error occurs. Trace files are generated in the working directory of the adapter. This is set in the TRA file by using the `application.start.dir` property. Note: When attaching SAP GUI to the client connection, verify that the information documented in SAP OSS note 1258724 is valid for your SAP system. If the information mentioned is not available in your SAP system, an error occurs when starting the adapter configuration.

Fields

Description

Name

Specify the client name.

The default name is ClientConnection_NameClient0.

RFC Trace

Set the value to 1 to enable RFC trace.

Set the value to 0 to disable RFC trace.

The default value is 0.

Note: Even though you disable the RFC trace in the adapter configuration, a trace file can be generated due to the setting defined in the RFC destination in the SAP system or parameters defined on the SAP Gateway.

USE SAP GUI

Set the value to 0 to disable SAP GUI to carry out debugging of RFCs.

Set the value to 1 to enable SAP GUI to carry out debugging of RFCs.

Set the value to 2 to enable SAP GUI to carry out debugging of RFCs until used by an invocation of an RFC.

The default value is 0.

It is good practice to install the SAP GUI on the same machine as the adapter.

If you enter other values, an error occurs.

Trace files are generated in the working directory of the adapter. This is set in the TRA file by using the application.start.dir property.

Note: When attaching SAP GUI to the client connection, verify that the information documented in SAP OSS note 1258724 is valid for your SAP system. If the information mentioned is not available in your SAP system, an error occurs when starting the adapter configuration.