Applying Policy

To apply the registered policy to a target operation, perform the following steps:

Procedure

  1. Start the Config UI, if not running.
  2. Log in to the Config UI using your credentials.
  3. Create a new configuration or select an existing configuration.
  4. Click the SECURITY tab.
  5. Click the Policy Binding tab on the top menu.
  6. Click the Add Property icon to add a new policy binding.
  7. Specify the following parameters for the policy:
    Policy Binding Parameters
    Type Description
    Policy Specifies a name for the policy. The policy name must be configured under the Policy Mapping tab.
    URI Specifies the URI of the operation to which the policy is applied.
    Facade Operation Specifies the facade operation to which the policy is applied. The facade operation must be configured in the Facade Operations tab.
    Binding Specifies the binding component that the policy is applied to. The possible values are service and reference.

    Select service from the drop-down list.

    Flow Specifies the flow of the request. Select IN from the drop-down list as this is applicable only to the facade operation (service).
    Target Operation This field is not applicable for user authentication using the file resource.
  8. Save the changes to the project or configuration.