Policy Binding

Using the Policy Binding tab on the Config UI, you can associate a registered policy with one or more target operation endpoints.

To map a policy to a target operation, follow these steps:

Procedure

  1. Click the Policy Binding tab.
  2. Click the Add property icon to map a policy file.
  3. Enter the details for policy mapping configuration, as follows:
    Policy Mapping Configuration Parameters
    Parameter Description
    Policy Specifies a name for the policy. The policy name must be configured under the Policy Mapping tab.
    URI Specifies the URI of the operation to which the policy is applied.
    Transport Specifies the transport of the request.

    For example, HTTP, HTTPS, JMS, or SOAP.

    facade Operation Specifies the operation to which the policy is applied. The facade operation must be configured in the Facade Operations tab.
    Binding Specifies the binding component that the policy is applied to. This could be either a facade operation (service) or a target operation (reference).
    Flow Specifies the flow of the request. The possible values are:
    • in
    • out
    Target Operation Specifies the target operation. The target operation must be configured in the Target Operations tab.