FUSNODE

You can use the FUSNODE exec to display information on enabled NODE definitions.

Required Parameters

This exec does not has required parameters.

Optional Parameters

The following table lists the optional parameters of the FUSSCMD exec:

Parameter Description
CONFIG | CFG Defines the configuration file used by the FUSNODE exec.

If this parameter is not defined, the platform server REXX uses the default configuration.

NODE Defines the NODE definition on which detailed information is to be displayed.

If this parameter is not specified, a list of enabled NODE definitions is displayed.

INIHOLD Modifies the defined NODE definition to turn on the Initiator Hold flag.

This indicates that initiator requests to this node will not be dispatched. The NODE parameter must be defined.

INITREL Modifies the defined NODE definition to reset the Initiator Hold flag.

This indicates that Initiator requests to this node will be dispatched. The NODE parameter must be defined.

RESPHOLD Modifies the defined NODE definition to turn on the Responder Hold flag.

This indicates that the responder requests from this node will be rejected with a recoverable error. The NODE parameter must be defined.

RESPREL Modifies the defined NODE definition to reset the Responder Hold flag.

This indicates that the responder requests from this node will be accepted. The NODE parameter must be defined.

Return Codes

The following table lists the return codes of the FUSNODE exec:

Return Code Description
0 Indicates that the platform server has successfully displayed the message.
5 Indicates that the NODE was not enabled.
Any other return code Indicates a network error occurred when processing a request.

Example

The following is an example of using the FUSNODE exec to display information on enabled NODE definitions:

FUSNODE N=TESTNODE

The output of this example is as follows: 

ONode Name...........= TESTNODE
IP Address..........= 192.192.100.10 
IP.Port.............= 46464  
STATUS..............= Normal       
SSL.................= No           
Protocol............= *Default     
Parallel............= YES          
Cont.Winners........= 00005        
Cont.Losers.........= 00005        
Encrypt.............= NONE         
retncode===> 0                     
utput