Integrating with TIBCO FTL

To install the TIBCO FTL client libraries for your TIBCO ActiveMatrix BusinessWorks™ environment, follow instructions in either of the following sections.

Prerequisites

The base version required is TIBCO FTL 5.2.1.

Using the bwinstall Utility

To install the TIBCO FTL client libraries for your ActiveMatrix BusinessWorks™ environment, run the following command from the <BW_HOME>/bin folder and follow the prompts: 
bwinstall ftl-driver

Using the TIBCO Universal Installer

Use the TIBCO ActiveMatrix BusinessWorks™ Plug-in for TIBCO FTL® to install the TIBCO FTL client libraries for your ActiveMatrix BusinessWorks environment.
Note: The FTL palette and the activities in the palette are available at design time and run time, after the plug-in is installed.

Procedure

  1. Run the TIBCOUniversalInstaller executable.
  2. On the Welcome screen, click Next.
  3. Read the license agreement, select I accept the terms of the license agreement if you agree to the terms, and click Next.
  4. Choose to create a new installation environment in an existing TIBCO_HOME. Specify the location that ActiveMatrix BusinessWorks is installed. Then click Next.
  5. On the Installation Profile Selection screen, ensure Typical is selected, and click Next.
  6. Provide the TIBCO_HOME path where you installed TIBCO FTL, and click Next.

  7. On the Pre-Install Summary screen, verify the list of products and components selected for installation, and click Install.
  8. Verify the Post-Install Summary, click Finish to complete the installation process, and close the installer window.