Verifying the Installation

After installing the MVS components and customizing the system SSL environment, you can start and test TIBCO Substation ES to determine if the basic components have been correctly installed and configured.

To verify the installation, complete the following tasks:
  1. Changing Substation ES Parameters
  2. Customizing a Console Interface
  3. Customizing Messaging Connectivity
  4. Starting Substation ES
  • Changing Substation ES Parameters
    Before starting the Substation ES region, you might have to change certain installed default parameters to help identify the target environments and personalize settings to suit operational requirements or site standards.
  • Customizing a Console Interface
    Substation ES enables administration and operational staff to communicate with an active system through the console of an MVS operator.
  • Customizing Messaging Connectivity
    To ensure the communication between TIBCO Substation ES and TIBCO Rendezvous or TIBCO EMS, you have to customize the messaging connectivity depending on which TIBCO messaging protocol you use.
  • Starting Substation ES
    After specifying all the required settings for establishing communications between Substation ES and a TIBCO messaging product, you can now start TIBCO Substation ES.