TIBCO Substation ES™ Installation

Software Release 2.10

May 2016

• Important Information
  
• TIBCO Documentation and Support Services
  
• Installation Requirements
  To install and use TIBCO Substation ES™, you must have TIBCO Rendezvous® for z/OS or TIBCO Enterprise Message Service™ (EMS) activated within your network. You must also load and configure the appropriate z/OS software before activating Substation ES.
• Installing and Verifying the Software
  After preparing your system, you can install Substation ES and then verify your installation.
• Installing CICS Interface
  After installing Substation ES and CICS Interface, you have to customize the CICS Interface that you selected as the BES.
• Installing RED Interface
  After installing Substation ES, you have to customize RED Interface that you selected during the downloading process.
• Installing IMS Interface
  After installing Substation ES, you have to customize IMS Interface that you selected during the downloading process.
• Uninstalling Substation ES
  You can uninstall the TIBCO Substation ES product by running the main member named SXX$9DEL from your USERHLQ.JCL data set.
• Substation ES Parameters
  Substation ES provides facilities and standard MVS methods for installation, administration, and operational staff to configure and administer Substation ES.
• Installed Data Sets
  The following table lists the downloaded data sets that are associated with Substation ES.

Copyright © Cloud Software Group, Inc. All rights reserved.