Perform Test Deployment on Select Nodes in a TIBCO ActiveMatrix Environment

To perform the test deployment of a Sample Application on a selection of Nodes from a particular Environment in the TIBCO ActiveMatrix Enterprise (as detailed in the Available Ant Targets section), you can run the following command: 

ant -f enterprise_healthcheck_build.xml test.deploy health.envs

The following is a sample output for the command:

Perform Test Deployment on Select Nodes in a TIBCO ActiveMatrix Environment

The names of the Environments used for this Enterprise Deployment Health Check execution are input from the enterprise_healthcheck_data.xml (see the following snippet): 

<?xml version="1.0" encoding="UTF-8"?>
<amxdata_base:Enterprise 
xmlns:amxdata="http://tibco.com/amxadministrator/command/line/types" 
xmlns:amxdata_base="http://tibco.com/amxadministrator/command/line/types_base" 
xmlns:amxdata_reference="http://tibco.com/amxadministrator/command/line/types_reference" 
xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" 
xsi:schemaLocation="http://tibco.com/amxadministrator/command/line/types_base 
../schemas/amxdata_base.xsd http://tibco.com/amxadministrator/command/line/types 
../schemas/amxdata.xsd">
   
<Environment xsi:type="amxdata:Environment" name="DevEnvironment" />
<DAA xsi:type="amxdata:DAA" description="DAA for deployment health check" location="${basedir}${file.separator}com.tibco.amf.admin.deployment.health.app.daa" />

</amxdata_base:Enterprise>
Note: The element <DAA> must be present for the deployment to succeed.

For performing Test Deployment for all the Nodes on given selection of Hosts, or just for a selection of Nodes, follow the same pattern as that shown above for the "do.ping" target, by replacing "do.ping" with "test.deploy".