Installing in Console Mode

Using the Console mode, you can install the software in a non-Windows environment. The installer prompts you for values.

You can install TIBCO MDM in console mode with the following options:
Note: You can move through the installation process as follows:

Press key or 1: Moves forward in the installer

Press 2: Goes back to the previous screen

Press 3: Cancels the wizard and exits the installation or uninstallation

Procedure

  1. On the command line, type the following command to launch the TIBCO Installer:
    $ ./TIBCOUniversalInstaller-lnx-x86-64.bin -console

    The TIBCO Universal Installer Welcome text is displayed along with the information about products to be installed.

  2. Press 1 to continue or 3 to cancel. If you press 1, the License Agreement text is displayed.
  3. Press 1 to continue reading or 2 to skip reading. If you press 1, read through the entire license agreement using the Enter key. If you press 2, the following question is displayed: Do you agree to the terms of the license agreement?
  4. Type Yes to agree to the license terms or No to exit this installer.
  5. Press 1 to continue, 2 to go back to the previous panel, or 3 to cancel. If you press 1, the TIBCO Home Selections options are displayed.
    • Press 1 if you want to create a new TIBCO installation environment.
    • Press 2 to select an existing environment.
  6. If you press 1, the following options are displayed:
    • Environment Name: Type the environment name. For example, MDMversion
    • Environment Location: Type the environment location. For example, /home/apps/MDMversion
  7. If you press 2, the existing environment name and locations are displayed:
    • Environment Name: For example, MDMversion.
    • Environment Location: For example, /home/apps/MDMversion
  8. Press Enter. The following confirmation message is displayed:
    Is this the TIBCO Home environment you want to use?
  9. Type Yes to confirm.
  10. Press 1 to continue, 2 to go back to the previous panel, or 3 to cancel. The Install Profile Selection options are displayed.
  11. Press 1 for Typical or 2 for Custom installation.