Defining Dimension Conditions Based on Custom Attributes

Procedure

  1. From the Add a Custom Attribute drop-down menu, choose the attribute you want to use for the current profile.

    All the attributes that you have defined are displayed in this menu, with the exception of Lookup type attributes that have no Lookup codes defined. Also, because you can target each attribute only once within any given profile, after you add an attribute to target to, it is removed from the menu.

    When added, each attribute is displayed within its own configuration panel. When you initially add an attribute to target, it is displayed in expanded mode.

  2. Configure the values associated with the attribute and click Update to save your changes.
    To save your work, click Save. Your input is saved and the page is refreshed, displaying the attribute panel in collapsed mode.
  3. If you want to define another custom attribute condition, choose another attribute from the Add a Custom Attribute drop-down menu, and repeat step 2.

Editing a Condition Based on a Custom Attribute

Procedure

  1. Click Save to save any existing work.
  2. Click the Edit button associated with the custom attribute.
    The collapsed panel is expanded. Only one attribute can be expanded and edited at a time. If you expand a block while editing another, you lose any input in the one you were previously editing.
  3. Configure the values associated with the attribute and click Update to save your changes.
    Note: If you attempt to set up a new attribute while editing one, your work is lost. Before adding a new attribute, be sure to click Update or Save.

    Refer to Administration: Custom Attributes for more information about Custom Attributes.