Out of Sync SystemNode after Upgrade

After upgrading from ActiveMatrix BPM 3.x or 4.x (with any ActiveMatrix 3.3.0 Hotfix installed on top of it), the SystemNode in the SystemEnvironment may be marked as Out of Sync. This is because the WSDL Validator is not correctly upgraded by the upgrade process.

Perform the manual procedure below to upgrade it:

Procedure

  1. In TIBCO ActiveMatrix Administrator user interface, select Infrastructure > Nodes.
  2. In the Environment field, select SystemEnvironment.
  3. In the Nodes list, select SystemNode.
  4. In the lower pane, select the Configuration tab.
  5. Using the pulldown menu button in the Features section, select Apply and Resolve.
    This stops, then automatically restarts the SystemNode. When this occurs, you will lose connectivity to the TIBCO ActiveMatrix Administrator user interface. Wait for about 1 minute and refresh the browser page until the user interface comes back. After the user interface reloads, confirm that the SystemNode is back 'In Sync'.
Next topic: Additional EMS Requirements for Installation and Upgrade
Previous topic: Refreshing a Node when Passing an Array to a Stored Procedure