Using a Load Balancer

If you have installed a BPM system using a distributed or highly available, fault tolerant configuration, you must configure the system to be able to communicate properly with your WCC application via the load balancer.

Information about configuring client communications through the load balancer can be found in the "Configure Client Communications Through the Load Balancer" topic in the TIBCO ActiveMatrix BPM Installation and Configuration guide.

To configure your custom WCC application to communicate via a load balancer:

Procedure

  1. Perform the steps in Task A as they are described in the "Configure Client Communications Through the Load Balancer" topic.
  2. For Task B in the "Configure Client Communications Through the Load Balancer" topic, you must configure your WCC application’s launch fragment in your development environment, rather than from the ActiveMatrix BPM node as described in steps of Task B.
  3. After configuring your application’s launch fragment in the development environment, you must repackage your application in a .war file, then redeploy it to the node. This is described in the "Deploying an Application After Customizing" topic in the TIBCO Workspace Configuration and Customization guide.