Importing a WSDL Document Into a Project

Procedure

  1. Right-click the Service Descriptors folder into which you want to import the WSDL document and select Import > Service Import Wizard.
  2. Select one of the following import methods:
    • Import from a File  Use this method to browse the file system for the WSDL document.
    • Import from a URL  Use this method to specify a URL that resolves to the location of the WSDL document.
    • Import from a UDDI Registry  Use this method to select a WSDL document from a UDDI registry.
      Note: The Descriptor for XML over JMS option is not supported by the BPM runtime. Do not use it.
  3. Click Next. If you chose:
    • Import from a File, browse to specify the Location of the WSDL document.
    • Import from a URL, enter the URL for the WSDL document.
    • Import from a UDDI Registry, the dialog lists any existing UDDI registries that you have added (see Creating a Registry on page 5). Expand a registry and select a WSDL.
      Tip: To add a new registry, right-click in the blank area of the dialog and select Add Registry. You can also add registry searches in this dialog using the right-click menus.
  4. Click Next.
  5. Browse to select the Project > Location (the folder in your project where you want to store the WSDL document), and if necessary change the name of the WSDL document. Select the Overwrite existing resources checkbox if you want to replace any existing WSDL documents with the same name.
  6. Click Finish.