Icon Plots - Advanced Tab

Graphical Analytic Techniques

Select the Advanced this tab of the Icon Plots Startup Panel to specify standardization options to use in the plots, as well as to mark selected icons.

Variables
Click the Variables button to display the standard variable selection dialog box, in which you can select the variable(s) for the graph. The selection that you make will then be displayed in the area of the dialog below the Variables button.
Graph Type
Select the type of icon plot from the Graph Type list on this tab. Click the desired icon plot link below for a brief description of that type of graph.
Chernoff Faces Polygons
Pies Columns
Stars Lines
Sun Rays Profiles
Standardize
You can control the standardization of the values of variables selected for the icon plot with the options in this group box.
Off
If you select this option button, then the raw data values will be used to create the icon plots.
Variables
Select this option button to standardize the values of the variables across cases.
Cases
Select this option button to standardize the values of the variables within each icon.
Twice
This option involves one regular standardization (i.e., across cases) followed by a standardization within each case (icon).

Except for unusual cases when you intend the icons to reflect the global differences in ranges of values between the selected variables, the values of the variables should be standardized once to assure the within-icon compatibility of value ranges. For example, because the largest value sets the global scaling reference point for the icons, then if there are variables that are in a range of much smaller order, they may not appear in the icon at all, e.g., in a star plot, the rays that represent them will be too short to be visible.

Mark Icons
Click this button to display the Specify Multiple Subsets dialog box, in which you can specify the cases whose icons will be marked (i.e., frames will be placed around the selected icons) in the plot. The line patterns of frames that identify specific subsets will be listed in the legend next to the text of the respective case selection conditions (as defined in the Specify Multiple Subsets dialog box).