Workspace Node: Breakdown Non-Factorial Tables - Results - Robust Tab

In the Breakdown non-factorial tables node dialog box, under the Results heading, select the Robust tab to access the following options.

Element Name Description
Summary Select this check box to produce a spreadsheet containing the statistics selected in the Location group box of this tab. Robust statistics, such as those calculated here, can give useful results even when certain model assumptions (e.g., normality) are not met. Because they are insensitive to extreme values in the data, robust location statistics should be used when outliers are present in the data.
Location Use the options in this group box to specify which location statistics to calculate.
Trimmed mean Select this check box and enter a percentage value to use in calculating the trimmed mean. Unlike the Winsorized mean (which replaces a percentage of values from the top and bottom of the data set), the trimmed mean is calculated by removing a percentage of values from both ends of the data set. A trimmed mean, therefore, is the arithmetic average after x-percentage of values has been removed from the highest and lowest ends of the data set.
Winsorized mean Select this check box and enter a percentage value to use in calculating the Winsorized mean. The Winsorized mean is the mean computed after the x-percentage highest and lowest values are replaced by the next adjacent value in the distribution. For example, consider an ordered data set with 100 observations: x1, x2, x3, … x98, x99, x100. If you specify a Winsorized mean with 5%, the bottom five percent of values (x1, x2, x3, x4 and x5) will be replaced with the next adjacent value in the distribution (x6). Likewise, the top five percent (x96, x97, x98, x99, x100) will be replaced with x95.

When the data are taken from a symmetric distribution, the Winsorized mean is an unbiased estimate of the population mean. However, the Winsorized mean does not have a normal distribution even if the data are normally distributed.

Grubbs test for outliers Select this check box to include the results for Grubbs' outlier test (Grubbs 1969; Stefansky 1972) in the resulting robust statistics spreadsheet. Based on the assumption of normality, this test can be used to detect a single outlier at a time. It is not recommended for use on samples with less than 7 observations. See Grubbs' Test for more information.

Options / C / W. See Common Options.

OK Click the OK button to accept all the specifications made in the dialog box and to close it. The analysis results will be placed in the Reporting Documents node after running (updating) the project.